BRAND NEW REMOTE UNIT
I found that the 97-99 ST204 Celica uses the same Alpine alarm used by the BMW E23 so I tried the instructions for that and it worked, so if anybody else needs this info here it is
My remote is P/N 08191-00900
1. Close all doors, trunk, and hood.
2. The security system must be in "disarm" mode. The key must be removed from the ignition key slot.
Enter Code-Learning Mode
3. Open the trunk and leave it open.
4. Open the driver's door and sit in the driver's seat.
5. Close the driver's door.
6. Cycle the ignition switch five times between the "off" position and position 2 (ignition "ON", all dash warning lamps will illuminate). The red status LED will illuminate continuously, and the siren will "chirp" once, to indicate that the code-learning mode has been initiated.
DO NOT START THE ENGINE
The ignition switch cycling in step #6 must be performed within ten seconds.
The sequence in steps #1-6 must be performed within 45 seconds.
Registering/Delete ID Code(s)
7. Open driver's door, (remain seated in driver's seat)
8. Close driver's door.
Edit: an extra step is required here for the Celica- cycle the ignition key once more from off to ignition on then back to off
9. Press and release any button on the remote you wish to register into the system. The status LED will shut off momentarily to indicate that one ID code has been registered.
10. Repeat steps 7 through 9 to register the remaining three ID codes.
Exiting Code-Learning Mode
11. Open driver's door, and exit from vehicle, leaving the door opened.
12. Close trunk.
13. Close driver's door. The LED will turn off and the siren will "chirp" twice.
14. The initialization procedure is now completed, test all remotes to confirm operation
SOURCE: 1996 Toyota Celica remote security system no longer works
Hi, Contact your dealer and get instructions for reprogramming your remotes. When a security system loses power for an extended amount of time the programming for the remotes are lost.
SOURCE: how do i program a remote control for a 1998
1-insert and remove key from ignition two times
2-close and open driver door two times
3-insert and remove key once from ign.
4-close and open drvr door twice
5-insert key into ign.,then close driver door
6-turn key to on (not start) then off, twice this is rewrite mode,have all remotes to reprogram it will clear any lost remotes.
7-remove key from ignition,the door locks should cycle twice.if not start over.it may take a few tries.
8-press lock/unlock together and hold for a second
9-release,and press lock on remote,the door locks will cycle
confirming program.continue to do other remotes you have,steps 8 and
9.if only one in possession,you are done. To end mode open door or insert key into ignition.
You'll need to follow the steps with no more than a 1-2 second delay between each step.. hope it works
SOURCE: Toyota celica vvti key programming
Put key in ignition. Hold down one of the key buttons and hold it down while you turn the ignition on. Door locks should pop up and down. Then release button and remove key.
Testimonial: "Thanks for the feedback. . is this programing done using the new key first or do i need to use my old key to start the Programming process thanks"
SOURCE: how to program bulldog TX4BL707 on Toyota Rav4
Do yourself a favor and return it to where you got it; get your money back. I have installed several of these for my customers and they all failed withing 3 months. Nothing but trouble, and, their customer support is very poor.
634 views
Usually answered in minutes!
×