My service stabletrack keeps come on how to fix that

Hi there:

Your vehicle is equipped with StabiliTrak, which combines antilock brake, traction and stability control systems and helps the driver maintain directional control of the vehicle in most driving conditions.
Traction control activates when the controller senses wheel spin. StabiliTrak will selectively apply the brakes and reduce engine torque to help regain traction.


Stability control activates when the controller senses a discrepancy between your intended path and the direction the vehicle is travelling. StabiliTrak selectively applies braking pressure at any one of the vehicle's brakes to help guide the vehicle in the direction which you are steering.


When you first start your vehicle and begin to drive away, the system performs several diagnostic checks to insure there are no problems. You may hear or feel the system working. This is normal and does not mean there is a problem with your vehicle. If driving conditions delay system initialization, the STABILITRAK NOT READY message may be displayed. If this is the case, your vehicle does not need servicing.


When the StabiliTrak system is both on and actively controlling the stability of the vehicle, the StabiliTrak light will blink for the duration of the event.


You may also feel or hear the system working. This is normal.
StabiliTrak will turn off automatically if a problem is detected in the system. The StabiliTrak light will come on and SERVICE STABILITRAK will be displayed on the DIC. For vehicles without a DIC, the StabiliTrak light and the StabiliTrak service light will both come on. If the SERVICE STABILITRAK message (or StabiliTrak service light) does not clear itself after restarting the vehicle, you should see your dealer for service.


Hope this helps.

The stabilittrak and service brake light would come on and stay on after 20 minutes of driving. I also realized the hatch wouldn't open when I used my door opener button or the button on the truck itself. We ended up just getting someone to look at the brakes. We needed to replace all 4 brakes pads, rotors, one calliper. The calliper was changed due to human error. These repairs fixed everything. Total parts were 900.00. I had my brakes changed before and I remember my hatch button didn't work then and asked them to fix it. Don't pay for that repair, I paid for them to fix this. The hatch problem fixes itself, once you change the brakes.

I changed my rear brakes on my 06 dts and now I get stabilitrak and traction control warnings. I had it reset last time by my tech but he moved. I just need the reset

[B][U][SIZE="4"][SIZE="6"][SIZE="5"]FINALLY FIXED, "SERVICE STABILITRAK & TRACTION CONTROL"[/SIZE][/SIZE][/SIZE][/U][/B]
[SIZE="4"][SIZE="4"][U][B]DIAGNOSTIC PROBLEM:[/B][/U]
"SERVICE STABILITRAK",
"SERVICE TRACTION CONTROL",
"HARD SHIFT 1-2 GEARS"-(STABILITRAK TURNING OFF-CLUNK NOISE)
"STABILITRAK OFF",
"TRACTION CONTROL OFF"
----------------------------------------------------------------------------------
[U][B]CAUSE:[/B][/U]
FUEL WAS 45% ETHANOL @ 85-(COSTCO GAS)-COMPUTER WENT INTO LIMP MODE CAUSING (AFM) TO GET STUCK AND NOT RESET COMPUTER.
----------------------------------------------------------------------------------
[U][B]SOLUTION:[/B][/U]
DRAINED & CLEANED GAS TANK-
CHANGED FUEL FILTERS (*ONLY IF NEEDED)
CLEANED INJECTORS-
RESET COMPUTER-
FILLED GAS TANK WITH NO ETHANOL- (http://pure-gas.org/index.jsp)
TOTAL AMOUNT WITH TAX: $444.86
----------------------------------------------------------------------------------[/SIZE]
[SIZE="3"][U][B]REFERENCES[/B][/U]
(STABILITRAK CLUNK NOISE): http://chevroletforum.com/forum/silverado-fullsize-pick-ups-21/2010-silverado-stabilitrak-question-47580/
(AFM)-Definition: http://en.wikipedia.org/wiki/Active_Fuel_Management
(ETHANOL): http://en.wikipedia.org/wiki/Common_ethanol_fuel_mixtures
(GAS STATIONS WITHOUT ETHANOL): http://pure-gas.org/index.jsp[/SIZE][/SIZE]