I just bought RAV4 2011.and never had Fog lamps. Please let me know how to install this lamps and how to do wireing.Thanks
This is a social web site,not an automotive
repair shop or tech line, with access to free info
On the fog lamp assy,I would crawl under a similar
vehicle & see if all you need to do is remove a cover
plate or drill some holes
On the wiring,I think the dealer parts dept will provide
some harness, that should plug in somewhere on yours
SOURCE: Wiring diagram to install OEM 2010 Toyota Camry fog lghts
here is a link that can help you.
http://www.donmar.com/Tech/FogLight-TCA-303.pdf
SOURCE: 2006 toyota rav 4 fog light bulb replacement
fIRST YOU SEE A RUBBER GASKET SURROUNDING THE HEADLIGHT PLUG IN THE BACK OF THE HEADLIGHT ASSEMBLY. pULL OFF THE GASKET AND LET IT HANG ON THE SURROUN DING HEADLIGHT WIRES. tHEN PULL OFF THE HEADLIGHT WIRE HARNESS BY GRABBING THE SOCKET (NOT THE WIRES). AROUND THE BULB IS A THIN SILVER HOLDING SPRING THAT LOOSENS BY SQUEEZING THE ENDS TOGETHER AND ROTATING IT. iT WILL LOOSEN AROUND THE HEADLIGHT. WHEN THIS HAPPENS THE HEADLIGHT WILL "FLOP" AROUND AND PULL IT OUT, REMEMBERING TO SEE HOW THE THREE CONNECTORS ARE LOCATED (I.E - IS ONE CONNECTOR AT 12 O CLOCK POSITION AND THE OTHER TWO ARE AT 9 AND 3 OR ARE THEY AT 3,6 AND 9, ETC.). rE-ASSEMBLY IS THE OPPOSITIE. tHE TRICK IS TO GET THE THIN SPRING WIRE BACK IN PLACE. YOU HAVE TO SQUEEZE THE SPRING AND RE-POSITION IT SO IT KEEPS THE BULB SECURLY IN PLACE
Having just changed the bulb, I would advise taking the whole headlight assembly out first. It is near impossible to feel or imagine how to change the bulb without seeing it. First, use a phillips screwdriver to take the single screw holding the strip off just below the headlight assembly. By doing so, you will now see the other two bottom bolts holding the headlight in. Take all four bolts out then disconnect the bulb from behind. Then proceed as above.
SOURCE: need wiring shematic for fog lights 2005 toyota corolla
im pretty sure these cars were already prewired for fog lights .there should be some plugs behind the bumper to fit them.if not get back i will explain how to wire them up.best of luck.
SOURCE: i need a wiring diagram for fog lights oem to my toyota
The link below is a Typical fog lamp / driving lamp hookup. Keep in mind that in most states, for these lamps to be 'legal' (and thus pass inspection), you must wire them such that:
1. You can cut them off (in other words, there must be a switch installed to turn them off)
and
2. They may only be operated with the low beams. (therefore, you must power your on/off switch from the low beam circuit)
http://www.accessconnect.com/fog_driving_lights_wiring.htm
SOURCE: how to install OEM 2007 camry fog light?
Follow the link below to find with picture and step by step instruction to mount the foglights. It's lot easy than connecting the wires.
http://meandmycamry.freeservers.com/photo.html
For me I managed to install the foglights but not sure how to connect to the power and bring the wire to the dashboard. My car didn't come with wiring connections for foglights. Would appreciate if someone can help me with that ( possibly instructions with pictures), Thanks.
1,413 views
Usually answered in minutes!
×