How do i raise and lower the headrests on 2010 chrysler town and country

You can check the fuses, but you really need an auto electrician. Their pro grade scan tool computer will diagnose the issue.

https://www.google.com/search?q=mobile+auto+electrician+near+me

Chrysler Town & Country (2008-2016) fuses

Fuse-Box.info https://fuse-box.info > chrysler > chrysler-town-countr...

Here you will find fuse box diagrams of Chrysler Town & Country 2008, 2009, 2010, 2011, 2012, 2013, 2014, 2015 and 2016 get information about the location ...



..

https://fuse-box.info/chrysler/chrysler-town-country-2008-2016-fuses#2010

Also check the relays.

check this out
https://www.google.com/search?q=2010+chrysler+town+and+country+Speed+Sensor+location&rlz=1C1NHXL_enUS713US714&oq=2010+chrysler+town+and+country+Speed+Sensor+location&aqs=chrome..69i57.50489j0j9&sourceid=chrome&ie=UTF-8

Chrysler Town Country 2008 2010 Shop Service repair manual


for better result of your problem click the link

Pull the headrest up toward the ceiling as far as you are able. There is a small plastic button on the side of one of the metal mounting rods (that go down into the seat). Depress and hold the button and pull up again. The headrest will come right out.

You have to find a small button located on top of the seat where the leg of headrest gets in. Press the button and pull the headrest at the same time.

Good luck.

Pull the headrest all the way up. Where the two rods go down into the seatback you will see a small hole in each of the plastic mounts. All you have to do is push a paper clip into the hole and lift theb headrest up to remove it. Do this for each rod. To reinstall just push the rods back in. Thanks for visiting I hope I solved the problem for you.

To remove the back seats.Lower headrest, fold seat down.Pull up on the release lever at the bottom on the right, tumble seat foward. Pull the release ******** the bottom of the seat to unlock the front

They use a nylon/plastic gear to raise and lower the window. It sounds as if that gear has gone the way of the dinosaurs. I believe they call the assembly the window lift regulator and it is available. Will probably be cheaper to buy thru Rockauto on line.

1. Remove or disconnect the following:
   • Negative battery cable
2. Raise the vehicle and support the fuel tank with a transmission jack.
   • Fuel line from the front of the tank
   • Ground strap
   • Inboard side of the fuel tank straps and front T strap fastener and lower the tank about 6 inches
   • Fuel lines from the fuel pump module
   • Fuel filter
3. Installation is the reverse of removal. Tighten the fuel filter bolts to 40 inch lbs. (4.5 Nm), the main tank straps to 40 ft. lbs. (54 Nm) and the T strap to 250 inch lbs. (28 Nm).
4. Start the engine and check for leaks.