20 Most Recent
2003 Toyota Corolla Questions & Answers
Toyota 5afe head bolts torque
Toyota 4A/ 5A-FE Cylinder Head Torque:
(a) Apply a light coat of engine oil on the threads and under the heads of the cylinder head bolts.
(b) Install the plate washer to each cylinder head bolt.
(c) Install and uniformly tighten the ten cylinder head bolts in several passes in the sequence.
Torque: 60 N-m (610 kgf-cm, 44 ft-lbf)
HINT: Cylinder head bolts are in length of 90 mm
(3.54 in.) and 108 mm (4.25 in.). Install the 90 mm
(3.54 in.) bolts (A) in intake manifold side positions.
Install the 108 mm (4.25 in.) bolts (B) in exhaust
manifold side positions.
I need to know where
Under the panel between the back window and the trunk lid opening, on the outer edges of the trunk opening.
2 small knobs that look like little cigarette lighters.
I have a problem with a fuse to EFI toyota corolla 2003
Hi there:Sounds like to have a fuel pump that is shorted out or has too much
resistance, this can cause to much of a current draw and blow the fuse. The EFI fuse supplies voltage to the EFI relay and then the fuel pump.Hope this helps; also keep in mind that your feedback is important
and I`ll appreciate your time and consideration if you leave some
testimonial comment about this answer.Thank you for using FixYa, have a nice day.
Reset of anti theft 2003 toyota carolla
to reset the anti-theft, put key in ignition, turn to on but do not start, you must leave in ON position for exactly 10 minutes, once the light shuts off, immediately start car.
'03 Toyota Corolla 1,4 VVT-i 4ZZ engine idle rpm
Idle is factory set and cannot be adjusted, your best bet is checking for cracked hose pipework for air intake at idle,(not at problem under exceleration and driving) Any slight upset to the air /fuel ratio will be most prevelent at idle speeds.Check hoses where the meet metal flanges on manifold intakes and any sharp bends in ppipes.Good luck
Not finding what you are looking for?