20 Most Recent 2000 Daewoo Nubira Questions & Answers

Does your your alarm ligth stay on when switch car on? If it does then ther is a problem with your car alarm system.

Under your stearing rack is a white box. Take it to your local car alarm dealer to get new car ship and get new ship melted in your key.

Yes I would

Write down a diagram of how the belt runs marked with O to mark where the pulleys are undo or release tensioner remove and replace belt.

You need to determine where the oil is leaking from. Could be oil pan gasket or drain plug. Look for damage to the oil pan. The damage might be minor but bad enough that the pan won't seat tightly on the engine

Battery is good?

Replace it.

Start with changing the oil. The oil filter might be plugged.

Hi Brian Is it stuck ON or OFF? Is it the same for all belts? A switch is either a physical one on each belt buckle or a continuity formed between the clasp & the buckle. Could be a fuse Either way.... A 12 volt test bulb would be useful here A quick test across each fuse with ignition turned on. Good Luck

there should be no adjustment needed as long as your rear drums are auto adjusting as they are suppose to.

There is 2 possibilities. if it has the marks on the valve cover as in the first picture then use those to align the cam gear timing marks to. If no marks on the valve cover then point the cam gear timing marks at each other as per the pictures then align the crankshaft timing marks as pictured.

Correct pressure at the fuel rail should be greater than 35Psi.

Try a check the tepreture sensor if its not working well it cause such problem . Change it if posible. That sensor can cause injector to shurt down they wont allow fuil in the engine .

blown head gasket or even warped cylinder head are possibilities.

This Utube video may be helpful. https://www.google.com/url?sa=t&source=web&rct=j&ei=YzhuVYefHMeZoQSz4YHIAw&url=http://www.youtube.com/watch%3Fv%3DWPPlgihDzak&ved=0CCIQtwIwAA&usg=AFQjCNFNkH-7bgspU2gUjH64G8xT_rInVg&sig2=FmnITdRd7frW2omLjDOBNw Bob

Either welsh pugs rear or front will require the removal of manifolds strange the welsh plugs need replacing though would be uncommon it is time consuming have you checked the o ring around the water pump as this is more common