20 Most Recent 2002 Saturn Sl - Page 3 Questions & Answers

just remove the bulb.

So you wasted your time at Advance Auto All they did was check for codes You check for codes Diagnose the codes Component Test--- to find a problem The vehicle has to be road tested with scanner along & you to explain things & look at all data You do not need codes to work on any vehicle & find a problem If all you do is drive it & never do any Preventative Maintenance,then that has to be done as well You could easily spend a thousand dollars to straighten out ALL the vehicles issues, if you have not been working on it several times a year You went to Advance You have the codes they found Google your codes & read up on the issue

Fuel filter may need replaced. Partially clogged causing low fuel feed under power

if it is a 2.2L ecotec, the starter is on the front of the engine, more or less below and to the left of the battery. on the other hand if it is a 1.9L the starter is on the back of the engine and you are not going to get at it unless you have a lift and a good tool set. i think the S type had the 1.9L and the L type had the 2.2, i am only familiar with 99 and older S types. my 01 L had a 2.2L.

Yes, this will prevent you from passing a smog check in every state (assuming the inspector is diligent enough to see the crack, or the crack is big enough that you can hear or smell the exhaust leaking). It's a good idea to get this fixed anyway since noxious gases are leaking out of the crack and can enter the passenger cabin.

reset the CPU as the program may have been corrupted by the battery change over.

Does the check engine light come on? if yes Could be faulty crankshaft sensor

Check the coolant level thats why the light is on and more than likely why the heater is not working.

WHAT ABOUT ANY SPARK HT-LEAD NOT WORKING AND IS GIVING MISFIRING AND ERRATIC IDLE. WHILST ENGINE IS RUNNING,PULL ONE BY ONE TO FIND THE NOT WORKING ONE.

is automatic if is standard if is standard maybe a bad clutch.

did you mark wiper motor arms and wiperarms shaft for reassembly sound like something not back in the right location.

Intake manifold gasket. Leaking where intake meets head.

make sure enough freon and cooling system has been bleed (get air out) if so ,change coolant temp sensor