Hyundai Motor 2002 Elantra - Answered Questions & Fixed issues
Turn signals and hazard not working on Hyundai
Make sure the 3 prongs (2 silver & 1 gold) line up to connect properly when you put it back in. I had to pullout the gold outside of where the bulb sits and slightly pull out the 3 in the actual lens to get a good connection. ***This is what makes the turn signal wireless... They have to be aligned and have contact****
6/6/2019 10:23:24 PM •
Hyundai Motor...
•
Answered
on Jun 06, 2019
•
3,072 views
I need the location of Fuel cut off relay in a 2002 hyundai elantra
The best solution you'll get from books at
www.reliable-store.com
These are books containing info on repair, service, troubleshooting, parts info, assembling dissemble, removal, error/fault codes, wiring diagrams and everything on any vehicles cars, atv, trucks. forklifts, boats, excavators etc
Low Idle, also shaky engine after fill up
you have to mention the make and model that is being tested
there are codes but if it is a GM product many scan tools will not read the faults because it requires a scan tool with a special protocol for GM
if it is a nissan , the ECM has a small screw that has to be turned to get the codes to read
The car is playing so rest assured there are fault codes but who ever is doing the reading is using the wrong scanner or is not familiar with your make of car requirements
Input and Output Speed sensors changed but car is still not running.
You don't say if you had it checked for DTC's - diagnostic trouble codes ? Have a scan tool that views sensor data hooked up . See what the PCM/ECM or TCM is see for input data . Your best bet mite be to take to a qualified repair shop that has the diagnostic equipment an knowledge to find the problem . Rather then guessing an just replacing parts .
Where is the first fuse box located
One is under the hood on the drivers side. The other is behind the little tip out tray by the drivers left knee. Open the tray and pull up to remove.
VEHICLE SPEED SENSOR
The VSS sensor is located on the transaxle .
If the VSS is defective replace the instrument cluster
3/20/2016 9:02:26 PM •
Hyundai Motor...
•
Answered
on Mar 20, 2016
•
1,076 views
Not finding what you are looking for?