20 Most Recent
Hyundai Motor 2002 Elantra - Page 9 Questions & Answers
There is a squealing noise when I turn the steering wheel.
Possible solution may be a new serpentine belt. When you turn the steering wheel it is an added torque/tension against the belt from the power steering drive pulley. A worn and dry belt may tend to squeal as the extra grip on that pulley is applied. You would have to pinpoint just where the squeal is coming from to be sure the power steering pump is the origin of the noise. There may also be other reasons if its due to a worn out belt, idler and tensioner pulley's could be making noise as well.
Hi, I have a Hyndai Elantra and the engine light
Apparently so - P0501 is a speed sensor code,
FAILURE CONDITIONS
The ECM will set a code and the Malfunction Indicator Lamp (MIL) will turn on if there is no vehicle speed sensor output signal for 20 seconds during two driving cycles when the following conditions are met:
a.
Open between fuse and wheel speed sensor (WSS)
b.
Open between WSS and GND
c.
Open between WSS and ECM
d.
Short to battery or GND between WSS and ECM
e.
Faulty WSS
However, the other, P-456 is an EVAP system code:
a.
Fuel filler cap loose or missing
b.
Fuel filler cap o-ring missing or damaged
c.
Faulty or damaged fuel filler pipe
d.
Leaking, disconnected or plugged fuel vapor lines
e.
Fuel in lines due to faulty rollover valve, on-board refueling vapor recovery valve or stuck closed CCV
f.
Canister close valve clogged, stuck open or closed
g.
Improperly installed purge solenoid valve
h.
PSV stuck open or closed
i.
Faulty fuel tank pressure sensor
j.
Leaking canister or catch tank
a.
If any codes relating to FTPS, CCV or PSV circuits are present, do all repairs associated with those codes before proceeding with this troubles area.
b.
If DTC P0455 is stored and MIL is illuminated, before proceeding to evaporative system test and repair, verify whether the customer was running the engine during refueling.
c.
If an obvious cause for DTC P0455 is an engine running during refueling, erase the DTC P0455 using Hi-Scan and do not repair the evaporative system. However, the vehicle should be monitored to find reoccurrence of the concern which may come from actual evaporative system.
When i make a sharp
You have a bad constant velocity joint and will have to replace the left drive shaft.
My clock constantly flashes and
This is a very common issue with this, and many
other clocks of this era. I offer a repair solution with a lifetime
guarantee. Check it out: www,autoclockrepair.com
I have info on how to remove the clock etc there as well. Drop me a note if you have any questions, thanks!
As for the AC coming on with the defroster, this is totally normal. Many cars do this by default
Not finding what you are looking for?