20 Most Recent 2006 Land Rover Range Rover Questions & Answers

turn on your bluetooth on your samsung while truck is on. it will scan for your range rover. phone will ask for code type in 2121. i have a samsung note 3 and thats the code i use. im assuming it"ll work on any samsung phone.

Hi, thanks for your input. I can not see the images of the electric circuits well. Could you send me the personal attachments corresponding to the multifunction radio-display of a 2005 Range Rover L322? Could you tell me which cable sends the start key signal?Many [email protected]

You car thinks it is or is in access mode or in extended height mode.

Try pushing the button again to reset the system. You can also look in the owner's manual for answers.

1 - Radiator 2 - Thermostat housing 3 - Radiator bottom hose 4 - Viscous fan 5 - Water pump 6 - Radiator top hose 7 - Heater return hose 8 - Coolant supply hose 9 - By-pass hose 10 - Radiator bleed (purge) hose 11 - Bleed (purge) hose, thermostat housing 12 - 'Y' piece ejector 13 - Expansion tank 14 - Heater rail 15 - Heater unit 16 - Heater feed hose 17 - Intercooler 18 - Air cleaner 19 - Air feed hose 20 - Turbocharger 21 - Charge air supply hose 22 - Cooled charge air supply hose 23 - Exhaust manifold 24 - Engine oil cooler 25 - Feed pipe, engine oil cooler 26 - Return pipe, engine oil cooler 27 - Oil filter

replace Maxi fuse 64. also follow this link it will help you out with a ton of stuff on your range rover. http://www.rangerovers.net join the forum that they have. there are all kinds of range rover nuts out there. I’m happy to help further over the phone at https://www.6ya.com/expert/dennis_7c5f8bf265aab5e9

Usually near the rear wheel same side tge gas cap is on

Possible causes of OBD code P0730 - Low transmission fluid level - Dirty transmission fluid - Shift solenoids - Shift solenoids harness or connectors - Transmission mechanical problems - Transmission hydraulic control circuit The Error code is generally activated on detection of the following conditions: The TCM has detected that the transmission is trying to mechanically shift to a lower gear than intended Possible causes of OBD code P0735 - Low transmission fluid level - Dirty transmission fluid - Shift solenoids - Transmission mechanical problems - Transmission hydraulic control circuit The Error code is generally activated on detection of the following conditions: P0735 is detected when A/T cannot be shifted to the 5th gear position even if electrical circuit is good.

Look at the positive cable. Is it corroded. Corrosion will also go into the cable under the rubber coating several inches. Clean it or replace it if it is real bad. Also clean the negative side and check the grounds from the battery. Three main ground wires are, battery engine, battery to body, and engine to body.

encrypted software ----dealer only

See www.graemecooper.com.au for a full list of model codes

Hi,I thought they where in the boot as you look in the boot on the write behind the cover.

you can also disconnect the negative of your battery cable.

If you used this scanner to diagnose the problem in your car then you can use the scanner to reset he check engine light. An alternative is to remove you negative battery cable for 15-20 minutes, or if repair has been successful drive car for 50-150 miles ( not all in one day ), and let the cars computer relearn the correct functioning of new part. LUCK FRIEND.

the inside of the wiper could be stripped out and have no tension to move the wiper try pulling it off and changing it if not need to see how to take it of and maybe the motor could have stripped the gears inside itself.

Sounds like a fuel problem. With the switch in the "on" position, can you hear the pump running? Crack the union where the fuel line comes up to the injectors, crank the engine to see if fuel comes out. If not, check for power at the fuel pump (in the top of the fuel tank). You should have over 12V between the white wire and earth. Ignore the voltage of the green wire - that is the sender.

Land Rover OBD II Trouble Codes but pressure control of what?

Likely, that is the sound of your "wear indicators" because your brake pads are worn.