2003 Isuzu Rodeo - Answered Questions & Fixed issues
How do you remove captiva fuel tank
My brother has a Holden captiva 09, my brother put petrol instead of diesel, lucky he didn't start the car I was wondering how to drain the fuel if it doesn't have a drain plug??
7/28/2018 12:56:15 PM •
2003 Isuzu Rodeo
•
Answered
on Jul 28, 2018
•
1,477 views
P1312 2003 rodeo 3.2L and poor acceleration
get car fixed, that is what CEL on means, and codes mean.
if you want to learn car repair read the book?
are you asking for use to teach you 50 years school and experiences in a 3 inch text box. , really?
1312 just one code, and weak engine, misfiring or bogging ?
3.2L, 2 cams or 4, the 4 cam is 6vd1W engine.
Ignition current Sense System Secondary Line #2 Circuit, Confirmed
this engine has 6 COPS, (coils over plugs) so...
ever get a full tune up in last decade,?
bad spark plug #2
bad spark coil #2
for sure I dont know what engine you have, no photo of if
nor VIN code 8th digit telling me this key fact.
if you had, id be more accurate
left front coil bad or spark plug or omg the boot on it bad
$1.49 spark plug
$15 boot
$150 coil
the cheapone is the tune up part, what say do that first?
its a spark plasma code, the high voltage plasma is weak.
(fancy DTC this) like my jeeps have.
Wheel bearing replacement
25 days old.??
car has 4 wheels, must be guess end of car?
2wd or 4wd, yup , be different.
why not just log in to mitchells DIY and end the saga... google it)
ill toss coin for you, lands heads, for front.
front wheel bearings.
2wd
- Before servicing the vehicle, refer to the Precautions Section.
- Raise and support the front end.
- Remove the caliper from the anchor plate and suspend it out of the way.
- Disconnect the ABS sensor.
- Remove the rotor.
- Remove the bolts attaching the hub to the knuckle.
- Installation is the reverse of removal. Torque the hub bolts to 76 ft. lbs. (103 Nm).
4wd:
- Before servicing the vehicle, refer to the Precautions Section.
- Place the transfer case in 2WD.
- Raise and support the front end.
- Remove the caliper from the anchor plate and suspend it out of the way.
- Remove the rotor.
- Loosen the caulking around the front driveshaft nuts. Remove the nuts and discard them.
- Remove the 4 hub retaining bolts.
NOTE
If the hub is difficult to remove, install 2 long bolt in the bolt holes and strike them to loosen the hub.
- Installation is the reverse of removal. Torque the hub bolts to 76 ft. lbs. (103 Nm). Use new driveshaft nuts, torquing them to 181 ft. lbs. (245 Nm). Apply new caulking. The caulk should be free of cracks when applied.
Why does motor shut off when I turn on the heat and air?
Electrical issue. The heat or air draws more current and the electrical system probably drops voltage below the threshold the electronic control module can handle. First check that the Alternator is charging correctly. When running the system should have 13 to14.7 volts measured at the battery. If you turn on the heat/AC and it drops significantly you have a current draw issue (most likely bad fan motor, or short) If the voltage is below 13 volts when the car is running your alternator is likely bad.
I can not put my 4x4 2003 rodeo into 4wd.
old postput car on ICE (at least 1 tire) to shift.or off roadshift to 4wd moving slow as possible;your car is not AWD, (all wheel drive)nor is it TOD. IT IS PART TIME 4WD. ONLY.ITS NOT FOR DRY PAVEMENT OR EVEN WATER WET ONLY PAVEMENT ,AT ALL.rtmread the operators guideor thispeople been doing this since ww2 jeepshttp://www.fixkick.com/tranny/xfr-case/windup-hell.jpgboom, its for snow/ice or offroad.
Have a 2003 Isuzu rodeo 6 clyinder 4wheel . Starter turns over a little longer before cranking. Done tune up, changed out fuel regulator but still dose the same ,what is my problem . t
a little longer before cranking.
what does that mean?
dont crank,
cranks slow.
cranks (Fast) called normal.
cranks fast starts, then stalls.
cranks fast, starts easy, starts, runs and stays running, normal
at what point does it fail, and how exactly.
we can't hear it, or watch you, so...................................
Not finding what you are looking for?