20 Most Recent 1997 Ford Windstar Questions & Answers

On this website you can find fuse box diagram for Ford Windstar https://www.autogenius.info/ford-windstar-1994-1998-fuse-box-diagram/

On this website (link below) you find fuse box diagram and description for Toyota Prius (2008) Toyota Prius Second Generation XW20 2008 2009 fuse box diagram Auto Genius And fuse box diagram and description for Ford Windstar (1997) Ford Windstar 1996 fuse box diagram USA version Auto Genius

Programming Electronic Door Lock Control System NOTE: The electronic door lock control processor (14B001) erases all previous keyless entry remote transmitter (15K601) from memory when the keyless entry remote transmitters are programmed or reprogrammed. The electronic door lock control processor can store up to four keyless entry remote transmitters in memory.

• To program (or reprogram) keyless entry remote transmitter into the electronic door lock control processor, perform the following steps:

1. Turn ignition switch to the RUN position and momentarily short the two terminals of the program connector taped to the wire assembly and located behind the glove compartment. All doors should lock and then unlock. Remove shorting pin.
   

1. Press any button on keyless entry remote transmitter. All doors should lock and then unlock to verify the keyless entry remote transmitter has been programmed. If door locks do not respond, press button again (up to three times maximum with the same keyless entry remote transmitter).
   

1. Repeat the above step to program additional keyless entry remote transmitters into the electronic door lock control processor (up to four keyless entry remote transmitters maximum).
   

1. Turn ignition switch OFF. All doors should lock and then unlock.
   

1. Check operation.
   

check to see if you have power to the wiper motor, if you do, and the motor is not coming on, and the switch has continuity, the motor is bad.

mcdevito75 here, It could be a few things, Fuel filter, fuel pump, the need for a tune up, one of the engine control sensors going bad. Have your local shop run diagnostics.

Yes it will work Just Fine Fix What Ya Can Ok do what Ya Can For Know Make it Work Ok

I/P Fuse Panel (Located Below Driver's Side of I/P) Engine Compartment Fuse Box (Located on LH Side of Engine Compartment)

If the stud pattern and off set is the same they will fit on. The problem is that regulation requires the ride height to be maintained which means that you will have to fit a lower profile tyre . For example if you use 15 " 205/95-r15 tyres then you may have to go to 205/65 r16 tyres . Talk with a tyre shop and discuss the legal requirements as far as insurance goes with a wheel size change

Our 97 ford wind star would jump after coming to a complete stop...i found a hose that sit on the manafold was off.....(look On top Or in Back) problem solved

Does engine turns at all and just won't start?

Reset the inertial switch (collision safety switch), located inside a compartment accessible from the inside of the vehicle, near the driver side rear lights. There should be an extruded red button which you press in to reset.

Stuck Relay for electric cooling fan. Dirty connections from Fan relay to cooling fan.