20 Most Recent
2006 Dodge Caliber Questions & Answers
I have a Dodge Caliber 1.8 SXT and want to change
Yes, the ATF4 is the correct transmission fluid to use in your Dodge Caliber. As for finding the fill plug it should be a bolt screwed into the side of the tail housing midway between where the gearshift goes in and the end of the transmission. Look on both sides. If it is not there, you may be required to pull the gearshift out of the transmission, this is not hard to do. Simple remove the gearshift boot cover and there should be 4 bolts holding what is known as the gearshift inspection plate. Remove these bolts with the gearshift in neutral, pull directly up on the gearshift and it should come out of the transmission, but by all means search for a fill plug first.
Dodge caliber radio code
call your dealer with vin# they will give you the code but as far as I know dodge don't have codes they reset themselves as long as they are in the vehicle they came from, try disconnecting the battery for a few minutes and see what happens ok, ttyl.
Wipers wont cut off
clean the body control module codes it might be stuck in limp mode aways done it with a scan tool but try disconnecting the battery
Hi i have a 2007
could that be P0008? I'm not showing the code you've listed, but if you reply to this feed I will help you out
If it is the code I listed, then its this , P0008 Engine Position System Performance (Bank 1)
This error basically means the engine is out of Sync.The Camshaft and Crankshaft are out of position or at the very least think they are. Engine timing may be out and thus your engine is in danger of complete destruction. At the very least a camshaft sensor maybe down.
Take the vehicle to a mechanic so they can check the timing issues
Interior lights stay on when
look into the sentinel switch, this is what allows your light to work with a delay. there may be another name for it but that is what I've heard it referred to as. i hope this helps.
Not finding what you are looking for?