20 Most Recent 1994 Dodge Caravan Questions & Answers

english please and i be glad to help

bingo transfer smoked

The sliding door ajar switch has a tan/yellow and black wire going to the switch. Chrysler has issued a service bulletin for this problem and issue a bumper pad to prevent inadvertent door ajar warning. Try to find bulletin 08-21-94

Definition of 32?

for a belt to run off the pulleys , one of the pulleys will not be mounted parallel to all the other pulleys check alternator pulley for alignment, power steering for alignment and tensioner pulleys for alignment place a long straight edge across the faces of the pulleys to another pulley and see if it touches both side of the pulleys check the idler pulley for failing bearings that will not allow that pulley to run in line under tension

I would start off by trying to jump start the vehicle. If it starts and runs normal, that tells you the starter and engine are okay, and the problem is in the charging system - battery, battery cables, alternator, relays, etc.

Now if it doesn't start, I would take the belt off and see if I could move the crank manual with a wrench. If it rotates (CW) then most likely your starter is bad.

Make sure the battery is disconnected and the airbag.

If you don't have the equipment to check the system take it to Auto Zone, etc, and have them check the system. Just because it is a new part doesn't insure it is good. They can also run a check for the codes. Both checks should be without charge.

The check engine light could relate to something else - not your battery or alternator. If your battery isn't charging from the alternator an illuminated battery symbol would appear. It could be many things - low oil level, low coolant level, low windscreen washer fluid level. It could even be an electronic 'fault' - which a computerised diagnostic check would identify. If the battery warning light is illuminated the first thing you should do is to check the tension of the alternator belt. You say that a new battery and alternator have been fitted? Take it to an auto electrician - he should identify any fault within minutes.

most likely a manual gear box is it jumping out of gear indicates the the gear is not properly engaged --adjust linkages check gear lever for obstructions in mounted on the tunnel loose /incorrectly tensionedd bell housing bolts failed rear engine mounts drive line vibrations or possible badly worn gear teeth jumping out of gear is when the mating gears are not exactly in line and the slight angle makes one gear walk out of mesh with the other.

Either the wheel bearing is bad or you do not have the axle all the way into the transmission

If you are saying the front axle is having issues with a vibration while driving then you should take it back to the mechanic that did the work. The other things that need to be checked are the bearings and the cv joints. Also don't forget the tires, they could bee out of balance too.

Check answer to other post with the same question.

Sounds like a fuel issue. Hook a fuel pressure gauge to the fuel rail and start the van. You should have at least 40lbs of pressure. Unfortunately for you, Dodge put everything in the fuel tank as a unit, so if it is just a plugged fuel filter you are still looking at a high repair bill.

What engine?

I suggest check this diagram looking and using colour code (clikc image for zoom)...



Fig. 35: Engine wiring schematic-1994-95 Town & Country, Caravan and Voyager with 3.0L engine

The Vehicle Speed Sensor is located on Transmission / Transfer case.

Oil level may be low. Check your oil.