20 Most Recent
2001 Chevrolet Impala Questions & Answers
O1 chevy impala reads error on radio display...wont start.
???
TRY THIS!
30-MINUTE LEARN PROCEDURE
1. Turn ON the ignition, with the engine OFF.
2. Attempt to start the engine, then release the key to ON, vehicle will not start.
3. Observe the SECURITY telltale. After approximately 10 minutes, the telltale will turn OFF.
4. Turn OFF the ignition, and wait 5 seconds.
5. Repeat steps 1 through 4 two more times for a total of 3 cycles/30 minutes. The vehicle is now ready to relearn the Passlock(TM) Sensor Data Code and/or passwords on the next ignition switch transition from OFF to CRANK.
6. Start the engine. The vehicle has now learned the Passlock(TM) Sensor Data Code and/or password.
IMPORTANT: The vehicle learns the Passlock(TM) Sensor Data Code and/or password on the next ignition switch transition from OFF to CRANK. You must turn the ignition OFF before attempting to start the vehicle.
2001 impala- Traction, Abs, Brake lights on
abs sensor is built into hub[bearing]common problem when changing them and or brakes r that the sensor connection is not properly reconnected or wire got damaged recheck the sensor wiring and that connector is connected to clip by strut clip is part of system
I have a 2002 chevy
Usually valve body is stuck,flush?did they change trans fluid and filter if not recommended you change filter and a bottle trans x it helped a 2001 impala ls I had transmission was good till the day sold it
2001 Chevrolet Impala will not shut off unless you unplug the coil pack
Programming problems with the PCM. Anytime you change an engine or other major component it must match exactly with the PCM . If the pcm was replaced with the engine, then the message being received from the ignition module is not recognizable and the pcm will not shut off the engine. Either the PCM has to be re flashed by a professional to match your old ignition module.
Can the Body Module on 2001 Impala cause door locks, trunk lock and interior lights not to work?
ECM has nothing to do those thing's . Probably not A BCM problem either . Did the Garage check for DTC'S - diagnostic trouble code's ?
DTC B3064 or B3069
DTC B3127
DTC B3128, B3133, or B3138
DTC B3132
DTC B3137
DTC B3272
Did they test the electrical circuit's for these componets ? Looking at a wirng diagram to see what if anything these have in common ,power feed , ground etc. maybe . What kind of garage did you take it to . Just to let you know ,replacing any module on your vehicle would need programming , dealer .
How do i reset the anti theft system after i had already switched the ignition
The ignition key contains a coded transponder chip which is read via an antenna around or close to the ignition/steering lock and the code in the key must match the code in the car's immobiliser memory in order to start the car.
As the key came from a different car it will need recoding. Sometimes the chip is moulded in plastic and sometimes it is possible to take the key apart - in that case you should be able to fit the chip (like a grain of rice) to your new key.
If you are lucky placing the original key close to the new key while trying to start might just make it work.
Good luck!
Not finding what you are looking for?