20 Most Recent
2006 Chevrolet Cobalt Questions & Answers
Coolant senser
218 is about the right temp for the fan to come on. How hot does it get? Does it cool down when the fan comes on?
How do you turn off the traction control 2006
There's no switch to turn it off, it's tied into the antilock brake system. You could remove the ABS fuse which will disable BOTH systems, You should think about the implacations before doing that.
Im dowing the rear brakes on my cobalt ss
The pistons on the rear calipers must be "screwed in" because of the parking brake, and sometimes the parking brake lever must be removed to allow the parking brake adjuster to spin.
I was driving home tonight and all of sudden I
Check the drive belt,and the alternator,most likely if the belt is still on,and it is running on the pulleys ok,then the alternator maybe out,have it checked,with out the alternator working the engine will not perform.
Car stalls
My 06 cobalt is doing the same thing. i have cleaned the injection system still having the same problem. i am going to replace the fuel filter next. if this doesnt work , i have no choice but to consult a dealer.
I have a 2006 chevy
More than likely you need to have your blower motor checked and possibly replaced.
2006 Cobalt . The Gear shift is stuck in park.
theres a switch that controls the shifter when the brake is applied. try putting the car into gear with the key on accessory, not on. if it goes into gear the switch needs to be replaced.
2006 chevy cobalt LT. the key is stuck
Have you tried shifting the gears completely through and then putting the car in park. It sounds like the car isn't able to be put completely in park to release the key. Try putting the car in N and removing the key. Even thought the car may not completely be in park to release the key, The gear most likely is in park but not enough to make the switch/sensor to release.
Why doesn't A/C compressor work?
If there is an issue with the pressure in the system, the ECU will not allow the compressor to run.
Check the coolant high and low pressure point pressures are within specification.
How do you replace BCM on a 2006 Chevrolet Cobalt?
first thing first are you sure that your BCM box is bad what symptoms are you experiencing I had a similar problem just the other day I thought my BCM box was going bad my brake lights would come on and stay on and my cruise control would also not work do to my brake lights staying on I went on line to check this problem out and found out that this was an easy fix that my box might not be bad at all, if your having similar problems try this first go to your local parts store and buy you a tube of dielectric silicone compound unhook your ground cable on your battery go to your BCM box and remove the two big grey plugs once you have removed them open the tube of grease and put a finger full on your finger and rub it inside where the plugs go and spread it evenally as possible once done rehook your grey plugs and then replace your cover and then you can rehook your ground cable this is what i done to my car and it fixed my problem. hope this helps... Here also is the bulletin i went to just type in technical bulletin #08-05-009c and it will explain more about it.
Not finding what you are looking for?
