Pull out the cover over the gear switch selector. Then pull out the vent controller and make sure that the wiring connector is connected tightly to the back of the switch.
If you are under the car
look up on the back side of the block toward the drivers side near the transmission
it is held in place with 1 bolt (use a 10mm socket)
and 1 electrical connector
super easy to remove/reinstall once under the car
You need to take this in, the seal might have failed because of a bushing wearing out. It is not something that you can do without special tools and equipment.
Question re-written for clarity.
Question moved to model category.
There aren't any. The headlights are a function of the IPM (integrated power module). Fuse 36 is the control according to this.
Headlamp / Washer Control / Smart Glass
Vehicle Historyhttps://www.vehiclehistory.com > questions > whats-th...
Jul 16, 2020 - The head lamps are controlled by a fuse in the engine bay. To locate the integrated power module, open the hood and look on the driver's side of ...
2 answers ยท Top answer: The 2007 Dodge Caliber is noted for driver's side low beam headlights that f
The torque specification for the manifold to catalytic converter bolts on a 2007 Dodge Caliber RT with a 2.4L engine is 26 Nm (19 lb-ft). It's important to use a torque wrench to ensure the proper torque is applied to the bolts to avoid over-tightening or under-tightening, which could lead to problems with the exhaust system.
either the master clutch cylinder is bad or the slave cylinder is bad. The slave cylinder is difficult to bleed. You should use a mityvac to bleed system.. it will require 2 people and new fluid. never let master cylinder to get low on fluid.