20 Most Recent
2008 Dodge Caliber 2.4 Questions & Answers
Tell me what this means
This is generic code the ECM puts out when there is a transmission malfunction. It could be mechanical or electrical. You need a better code reader or scanner to pull the transmission codes.
11/10/2015 10:57:19 PM •
2008 Dodge...
•
Answered
on Nov 10, 2015
Torque spec for maniverter bolts on a 07 dodge caliber rt
The torque specification for the manifold to catalytic converter bolts on a 2007 Dodge Caliber RT with a 2.4L engine is 26 Nm (19 lb-ft). It's important to use a torque wrench to ensure the proper torque is applied to the bolts to avoid over-tightening or under-tightening, which could lead to problems with the exhaust system.
Where is the fuel filter on a 2007 dodge, caliber
The fuel filter is in the tank connected to the fuel pump most all new auto`s are doing that. Take it to a shop have them change it and by the way go ahead and change the fuel pump at the same time.
How to remove a Dodge caliber fly wheel
More information please. What exactly are you having issues with? Removing the actual flywheel isn't too difficult, it simply bolts to the end of the crankshaft. The hard work is actually getting to it.
You need to remove the transmission and bell housing as well as the clutch assembly to get to the bolts holding the flywheel to the crankshaft.
The transmission AND the actual flywheel are VERY heavy and I would not recommend doing this as a 'driveway' job.
*NOTE* - The mount holes on a flywheel and the crankshaft end are NOT evenly spaced. All six holes will only line up in one exact position. This is a marker setup to keep the system correctly balanced.
- Make sure the mount bolts are tightened to the correct torque setting! One loose bolt can cause a world of problems.
How do you remove cvt trans from 2007 Dodge caliber sxt 2.0
get a repair/service manual it will show tools-equipment needed as well as checking out if your capable of doing the removal https://www.youtube.com/watch?v=JXQgIu9IzTw this shows basic removal at a boneyard and the use of equipment there to remove it also not shown is the removal of all the components and sensors needed to get to bolts
Not finding what you are looking for?