20 Most Recent 2011 Ford Transit Connect Questions & Answers

NGK plug is TR55 series. .052 is the gap

with a voltmeter check for battery voltage at cable and bulb holder and a good earth there must be battery voltage , if ok check bulb , if ok check there is a good earth between lamp housing an car body.

I have a 2011 Ford Transit Connect, my daily driver. Today I drove and parked. I went to drive again and could not get the vehicle out of PARK. I called a tow truck in and the driver showed me the problem. There is a black cover near the gearshift lever that is similar in size and shape to a dime. It can be removed with a small screwdriver. Once removed, there is a white switch revealed. When you push down on the switch while pulling back on the gearshift lever, you will be able to shift out of PARK.

Hopefully they are not controlled,or given the signal, by the PCM (or ECM)? Some cars must get their signal from the computer......it's an inane,over-engineered system,I know. don-ohio (:^)

P0116: Engine Coolant Temperature Sensor 1 Circuit Range/Performance http://www.autocodes.com/p0116_ford.html P1229: Supercharger Intercooler Pump Not Operating Condition http://www.autocodes.com/p1229_ford.html

• P0735 Gear 5 Incorrect ratio

If your check engine light is on and your vehicle is newer than a 1996 you can take it to knechts auto parts and have them check the codes with a code reader its most likely a sensor like the mass air flow(MAP) sensor or throttle possision sensor(TPS) or it could be a pluged exhaust gas recirculation valve (EGR) but to know for sure you have to read the codes!

Usually the problem is inside the wiper motor. If you can see any contact points or can spray a little WD40 on what you see, it may help. Sometimes backing off the mounting screws and retightening them will allow the grounds to be reestablished.

Hello, the steering wheel can 'lock-up' in certain positions if it's internal mechanism is ''against the stop'' ie;limit of travel.try turning the wheel back & forth while pushing the key IN while turning key switch .If you get it 'ON',drive to a locksmith/key shop & have a new key made.IT IS THE 'POINT' OF THE KEY THAT UNLOCKS THE WHEEL;As the key wears out,it can't' REACH' THE unlock pin. best O' luck