20 Most Recent
2011 Ford Fusion Questions & Answers
Ford fusion radio code
I had the same problem. jumped the battery and then the radio didn't work, just said "ford fusion" on the display. you need to locate the fuse box down by the brake pedal to the left, very difficult to get at. once you find it remove the plastic cover and then remove the radio fuse (look in your owners manual for the fuse number and location). using a needle nose pliers works the best. once you remove the radio fuse look at it, the small metal wire inside should be broken. replace it with an identical fuse. my fuse box had spare fuse slots with same color and number on them so I just used one of those.
Boot wont open with key fob
Try standing at the rear of the vehicle, putting the fob against your temple and activating it... This realy works!
Replace the battery in the fob.
If all else fails buy a new one from the manufacturers.
Where is the fuse located on a 2011 ford fusion for the windshield wipers
They are usually under dash drivers side or under the hood drivers side. There should also be a relay as well. That to should be under hood drivers side. If your wipers are not working, check both. To check a relay without a meter, change the wiper relay with another one with same number and see if wipers work.
2011 fusion wrench light
Sometimes the service light puts the car into "limp mode" hence the poor performance. Might need a trip to a mechanic to diagnose the cause because intermittent faults are very hard to find.
How do I replace rear turn signal bulb
In the trunk there will be removable panels. Remove the panel closest to the light you want to replace.
The bulb or bulbs will be behind the panel.
Hope this helps.
My wife hit something on the passenger side of of her 2011 Ford fission now you can't steer it
Its like something is locking up
Now the axle on the driver side where it goes into trans is locking
start where the right side was hit jack up the car & see if there is bent tie rods and look at the drive axle on the right side it could be jammed all the way in because now the right side is pushed into far or the axle shaft has bent also look at the strut alignment if it's in to far it's forcing the axle inward and jamming the transaxle you must put the car on jack stands to do this at the same height you will see that something is bent or knocked out of alignment the right side will show the more inward angle also look at the engine & trans mounts they could have been broken and now the hole power plant is out of alignment good luck and use a good jack/stands to climb under the car and have someone else there with you who is competent to help you if something goes wrong your wife may panic and not really know what to do so get a guy who is knowledgeable about these things most women just don't know & this is nothing against them it's not there thing so please be safe! I know that your not a mechanic otherwise you wouldn't be asking here so thumbs up to you for trying and your safety is of great concern any time you get under a vehicle do it in a safe place where no Dumbo's going to hit the car while your under it,it's happened to me that's why I'm including this here I had a dude back into the car while I was under it I just made it out in time before he knocked it off the jack stands on a street where there was 100 parking spots he had to park there and back into the car no less idiotic behavior is always a concern be safe Rodney please be safe!
Not finding what you are looking for?