20 Most Recent 2011 Cadillac SRX Questions & Answers

I have the same car and I am having the same issue, it feels like the AWD isn't working. Have you found a solution yet?

Youtube has lots of answers along with a video.

The pedal has a little rubber stop on it. When the pedal is all the way off push it just a little and watch the light. If it turns off the little stop is bad. It goes in a small hole where the pedal arm rests against a bracket. Also a broken switch can cause this

FREE factory drawings are available on the BBB Industries website...AT bbbind.com (type that in as a URL... You should like it (FREE)). Registration is required (these are real circuit drawings and technical service bulletins (TSBs)). $1200 can buy a couple of tools... Good luck Anna Santos. Rockauto part http://www.rockauto.com/en/catalog/cadillac,2011,srx,3.0l+v6,1447704,electrical-switch+&+relay,power+seat+switch,4612 Detail More Information for AIRTEX WELLS 1S12380 Hope this inspires. Carnac the Magnificent

Probably a Bluetooth compatibility problem. Just because they paired doesn't mean the drivers in both devices are currently compatible (one of them may have been updated without you knowing). You will have to dig deeper and determine what the current Bluetooth versions are on each and then check compatibility.

If you are asking about the coolant level sensor, it is at the bottom of the coolant expansion tank. It is part of the tank so if it goes bad you have to change the whole tank. If you are having a problem with the tank reading low when it is full, the first thing to check is the type of antifreeze that you put in it. I had a water pump changed on my 2001 deville and they used green anti freeze and the sensor wouldnt read it.

Visit the on-line store, know as reliable-store, they have the repair manuals. I'm sure you will get the solution of your problem. Best Manuals

Look for short in wire harness coming from main body of vehicle to the hatch at top by the hinge. I had a wire wear through insulation and positive wire was rubbing on ground to hatch acting as if you were hitting the switch. Just look for worn wire at the point it is nearest metal access hole where wire harness comes through, should be obvious. Good Luck, FREE-PPV.com

Most likely the stock amplifier. Normally in the trunk above the seat in between the back speakers

Will not crank over or will not run ?

Normally all parking lights are controlled by the light switch. First turn turn on the parking lights and second turn turns on the head lights. Are you sure it is not your break lights staying on? if this is your break lights - look at break pedal for break light switch staying on or not adjusted correctly. Does your car battery gets drained from your break lights staying on?

Try jump starting it from another car. or that thing should have a volt gauge while trying to crank it if it drops lower then 11volts it wont start. or if you can hook up a volt gauge to the battery if not just try jump starting it.

Be very careful this is not for a novice it can deploy and seriously hurt you have it done by a professional