20 Most Recent 2008 Subaru Tribeca Questions & Answers

you cannot and the only ones who ?an fit batteries and re-programme the keys again is the dealer ,all vehicles from 2005 are like this ,its to stop people from doing it themselves and create easy cash for the dealers ,sorry i couldnrt help

for heavy machinery cars etc. luckily there are many websites that can help you repair for eg site like reliable-store is very active in this.. instant help, emails and all that's fantastic

You need a dealer, this is way beyond an amateur repair, comprendo?

Yes, fabrication of the necessary adapter brackets are required, and this will include welding.

Pry it open?

Have you checked; the fuses? The power connection? The ground connection?

Sounds like a bad ground at the battery. Remove terminals and clean. There are brushes made for this task, you can buy at a parts store along with the battery cleaner in a spray can. Use them both and this procedure works great.

Replace the volume control(rheostat) inside the radio. Only way to fix it. I would personally just live with it until one or the other quits working. Then replace the radio.

Hi, replacing the front wheel bearings on any vehicle is difficult if you don,t have the right tools, as the driveshaft and wheel hub (where the bearing is seated) needs to be removed. The hub housing the bearing may have to be heated (depending on corrosion) when the bearing is being pressed out, by using a heavy duty vice , and the new bearing is pressed in using the vice and the old bearing as a guide. I would strongly suggest you refer this repair to someone who has done this before, I personally would not undertake to change front bearings ever again, the first time for me was an experience I wouldn't want to undertake again. All the best.

Take the front tyre offUndo the brake caliper and hang it nearby (try not to kink the brake line)Remove brake diskThere should be a nut in the middle that needs to come off, might have a clip to remove first then unbolt.Slowly pull out the wheel bits and there you should have the bearing in grease in the middle.Simply switch for new one packed in grease, reverse the process and bob is your uncle....

some are plastic with a rubber boot that push into the hole in the panel and the wire clips on the back of the switch and others actually have a rubber boot with a nut under the boot that you undo and remove the switch,but make sure whichever one it is that you disconnect the power or it may short out and blow the fuse

It is related to the cam position sensor. If it has vvt timing. Low oil will affect it.

You can buy a 2008 Tahoe with bucket seats but I'm afraid I cannot find any information about switching out the seats. -------------------------------------------------------------------------------ELM 327 1.5V USB CAN-BUS Scanner