20 Most Recent
2009 Hyundai Sonata Questions & Answers
What fuse is for cruise control in a 2009 hondai sonata
nada
of cruise fails
scan the PC it tells you why
lean that on modern cars CRUISE is disabled for a long list of other failures.
any major engine failures.
any transmission failures.
any brake failures.
TWB errors, throttle by wire, TB or pedal.
and more.
check all fuse and scan the pCM or you will never know why.
this is for your safety , no more cave man cruise boxed now.
they are all gone now, and mostly dead years ago.cable cruise I call them.. cruise now is pure software.
TBW + cruise magic software = cruise to you.
the throttle is motor drive now. so cruise is pure software and 1 switch marked CRUISE+ resume.
Mecha error
it says there is a mechanical error meaning that there is an internal part no longer functioning yo need a radio
A red light blinks on the windshield on the center
It's part of the security system -- it let's you (and any potential thief) know that the system is armed. You can turn it off by not locking the car up when you leave, but that's not a very good idea. Other than that, maybe you could just cover it up.
How to replace fender on 09 sonata?
Well just so you know when you take it to a shop. Unless you own the shop you get in line and there fore you don't get it done right away. And if you don't know what your doing you may do more damage to the paint and cost you even more money. So to answer your question yes the fender is held on by bolts clips and screws. And you may end up removing the hood and front bumper and inner fender to get the fender off. Then put it all back together to get the correct body gaps is a must so the hood and driver door opens correctly.
We need to clean the
The wheel lug nuts hold the wheel covers on. You have to remove the lug nuts to get the wheel covers off.
Ignition replacement cost
put some paper down on the floor and spray DP oil into the ignition use spray can flush the ignition out, put key in and turn a few times and do it again with the spray, two or three time doing this over should free up the build up and pocket fluff out of the ignition leave to drip out onto the paper for a while afterwards.
Not finding what you are looking for?