Acura Cars & Trucks - Recent Questions, Troubleshooting & Support

Question edited for clarity. Question moved to model category. No, it is no a replaceable item and is located in the bottom of the fuel tank and is part of the fuel pump Attached to the fuel pump in the gas tank. It's not a replaceable part. You would have to replace the pump in the tank. Actually it is replaceable, but not a maintenance item. Apr 12, 2011

fuel filter location on 01 CL ? - Acura Enthusiast Community

AcuraZine https://acurazine.com > ... > 2G CL Problems & Fixes ..

You'll need to remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. If needed, you can pull back the weather seal (can't reuse it, but it's not that important) and you will be able to access everything inside the door

Here are the instructions to test the braking switch and related components to locate the fault. Brake Pedal Position Switch Test 1.) Disconnect the 4P connector from the switch (A). 2.) Remove the brake pedal position switch. 3.) Check for continuity between the terminals according to the table, using a multimeter. 4.) If the continuity is not as specified, replace the brake pedal position switch and adjust the pedal height. 5.) If OK, install the brake pedal position switch and adjust the pedal height.

Question edited for clarity and make sentences.Remove the unit, remove the connectors, spray them with electrical contact cleaner and then replace them making sure they are well locked into place.Or there is a dry joint inside the unit.Start with the easy stuff first.https://www.google.com/search?q=Acura+RLX+radio+turns+off+every+time+I+hit+a+bump..

2002 RL Acura Navigation screen is black

I want to clear vsa light on acura mdx 2008

So no crank, (the engine doesn't turn) and no start? Did you disconnect the battery during the starter install? Did you reset the anti theft immobilizer afterwards? https://www.google.com/search?q=2003+Acura+MDX+no+crank+no+start ..

Unlikely :>D https://www.google.com/search?q=2006+Acura+MDX+navigation+system+code+for+free ..

Two ideas here, in the under hood fuse box or under the bumper. https://www.google.com/search?q=1998+Acura+CL.+Where+is+the+a%2Fc+clutch+relay+located ..

It is a know issue Melissa and Victoria. Try the Reboot / Reset. https://www.google.com/search?q=2019+Acura+RDX.+Acura+Infotainment+system+is+fading+in+and+out...and+then+the+message+Drive+mode+change+unavailable ..

Question edited for clarity. Question moved to model category. Duplicate deleted, just Refresh page to see your question.

P1607 Acura Code Meaning, Causes, Symptoms, & Tech ...

Engine-Codes.com https://www.engine-codes.com > p1607_acura The Diagnostic Trouble Code (DTC) will set when the Powertrain Control Module detects an internal circuit failure.

I have a 2002 Acura 3.2TL Type S. It is giving me a code of ...

JustAnswer https://www.justanswer.com > Acura Repair Nov 30, 2010 - I have a 2002 Acura 3.2TL Type S. It is giving me a code of P1607, which is for an internal error in the Powertrain Control Module. 1 answer · Top answer: Hello, this isn't much more option to this code but a faulty pcm. You can try and find a ...

Code P1607 Acura Powertrain Control Module Internal ...

AutoCodes https://www.autocodes.com > p1607_acura The Diagnostic Trouble Code (DTC) will set when the Powertrain Control Module detects an internal circuit failure. OBDII Code P1607 Acura - Powertrain Control ... ..

Unhook the negative post of the battery for a minute and that should reset the computer.

need to remove the door panel ---if chid lock was on would be able to open using outer handle most likely linkage or clip fail

https://www.google.com/search?q=1999+Acura+CL+TCM+Location ..

Check for spark to the plugs and fuel to the injectors. A scanner would help to find a problem. First start by spraying a little starting fluid into the throttle body. If it starts, then check fuel pressure. You may have a bad pump or relay. If no spark, problem could be a bad sensor or bad connection to a module.

its really easey to remove the dvd unit under the pasenger seat. just put the seat all the way forward and pull the plastic guard from the seat track (pull straight back) then unplug the harness connectors in the back of the unit.
Then put the seat all the way back and remove the 1o mm nuts on the side brackets of the unit and pull it forward.

You can fix it by checking the disk and removing the error

Question edited for clarity and toss in some CAPS. Question moved to model category. When you replaced the fuel pump, you disconnected the battery, yes (because they tell you to)? You now need to reset the security system and engine immobilizer.

How do i reset the Acura immobilizer?

Vehicle History https://www.vehiclehistory.com > questions > how-do-... To reset the immobilizer on Your Acura, insert the ignition key in the driver-side door lock. Turn the key to the unlock position. Turn the key to the lock ... ..