20 Most Recent kawasaki 2012 Mule 4010 4x4 Questions & Answers

Question moved from Cars and Trucks. Wiring diagrams in the link. https://www.google.com/search?q=kawasaki+mule+fxt+le+fuse+box+diagram ..

Something is shorting to earth on the brake lights. Get a pack of fuses. Remove left side bulb. Brake, does is blow the fuse? Remove right side bulb. Brake, does it blow the fuse? If yes to the above, it is the light fitting or wiring rubbed through to that light. If no, it is the switch or wiring to the switch on the brake pedal. https://www.google.com/search?q=4010+4x4+diesel+mule+blows+fuse ..

I assume there is only ONE fuse, since you are not specific. The solution therefore is just hard work and long hours with your ohmmeter disconnecting wires and tracking it down one wire at a time.

Coil pick up runs the fuel pump also so u need to check the primary and secondary coil

Check your linkage connections. they may have come separated.

not familiar to your set up but as with any system encluding motor cycle. Get a hose and syphone all that you can out and fill with the proper gas. Start it up...it might be a little harder to start but once you get it started it will clear. I once had a guy fill my car with diesel...supposedly gas and I drove the car a long way then kept stopping up with gas. worked fine....sure did clean the engine.

i would return the mule to the dealer where you bought it,and let the warranty pay for the battery and testing,etc.

fuse block ? under dash, hood or seat. trace your wires to the fuses easy peasy

Will it start with starting fluid

Open fill cap and oil level should be full.

Hi ! for a fuel filter. please visit the website below. If you need more information about a specific electrical issue you can reach me at [email protected].http://www.motorpartstore.com.Good luck and have a nice day.

check under the seat in the fuse box to see if you have a bad fuse

First is the engine Diesel or Gas? if it is a diesel engine it has almost got to be a compression or fuel problem if it is a Gas engine it can be a valve adjustment, fuel, compression, or spark problem

Water on the belt shouldnt destroy the belt. It just makes it slip so you wont get full power out of it. If its wet & you are running it hard it could fry the belt.